Skip to content
New issue

Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.

By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.

Already on GitHub? Sign in to your account

2.4 GHz range cut due to Jetson RF noise #160

Open
gregdronsky opened this issue Apr 21, 2021 · 6 comments
Open

2.4 GHz range cut due to Jetson RF noise #160

gregdronsky opened this issue Apr 21, 2021 · 6 comments

Comments

@gregdronsky
Copy link

Hi,
we are working on a Jetson Nano, that is mounted on a drone, and we are having problems with the 2.4GHz range. When Jetson boots up, the range of Futaba 2.4 with Fasst protocol shortens by a lot, also 2.4 Wifi card located 20cm from Jetson has problems with the range due to signal noise caused by Jetson. Did you have any experience with that? We are not connecting any Wifi card to Jetson, only Ethernet cable. Also during the boot up of Jetson, it seems that GPS signal is being disturbed as well. Can anyone help me with that? I am out of ideas about what could be the cause.
Cheers!

@mtbsteve
Copy link

You need to mount the Jetson as far as possible away from the RC Receiver antennas and in particular away from the GPS. In addition, you may shield the Nano with EMI absorbing fabric.
Example source:
https://store.mrobotics.io/product-p/3m-emishield01-mr.htm

I am running a Jetson TX2 w/o any issues on my drone after I applied the 3M foil.

@gregdronsky
Copy link
Author

Hi mtbsteve,
thank you for you fast reply. Should I place the fabric in some particular place or just cover it all up in it? It is kind of expensive on farnell, do you think it will work for sure?

@nv-jeff
Copy link

nv-jeff commented Apr 21, 2021

We also found that USB 3 will interfere with the GPS signal as well as wifi (see here for an older investigation from Intel: https://www.intel.com/content/www/us/en/products/docs/io/universal-serial-bus/usb3-frequency-interference-paper.html) If I recall correctly, we used metal foil wrapped around the USB 3 cable to reduce EM interference.

@gregdronsky
Copy link
Author

Hi nv-jeff,
we have USB 3.0 connections. We will wrap it up with foil. Thanks!

@mtbsteve
Copy link

Yes, the USB3 port is actually the main source of EMI. I have applied the 3M foil right below the GPS module. So a 6x6 centimeters piece is fully sufficient.
The Rx antennas are mounted under the drone belly, with the carbon frame plates in between the Jetson and the antennas.
I use the 5GHz wifi for the connection with my GCS, so also no interference with the 2.4RC either.

@gregdronsky
Copy link
Author

That is valuable info mtbsteve. Thank You!

Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment
Labels
None yet
Projects
None yet
Development

No branches or pull requests

3 participants